底層運作原理
The resistor drops whatever voltage the LEDs do not use: R = (supply − number of LEDs in series × forward voltage) ÷ current. For a parallel bank with one resistor per LED each branch is calculated separately. With one shared resistor the currents add, so the resistor carries the total and the LEDs share it unevenly, which is why the tool flags that layout.
詳細操作步驟
Choose the layout: one LED or a series string, parallel with one resistor per LED, or parallel sharing one resistor.
Enter the supply voltage, the LED forward voltage from its datasheet and the target current.
Enter how many LEDs you are driving.
Read the exact resistance, the next standard E24 value, the resistor power and the real current with that standard part.
核心功能與效能優勢
- Three layouts in one tool
- Rounds up to the next E24 value so the LED never exceeds the target current
- Resistor power with a safe rating suggestion
- Warns when the supply is too low for the LEDs in series
運算方法、公式與技術標準
Ohm law on the leftover voltage. The standard value is the smallest E24 value at or above the exact result, so real current is slightly lower than the target.
實作範例與邊界案例
Three LEDs in series
12 V supply, 3.2 V forward, 20 mA, 3 LEDs in series
120 Ω, 0.048 W
12 − 3 × 3.2 = 2.4 V across the resistor; 2.4 ÷ 0.02 = 120 Ω.
Four parallel LEDs, one resistor each
9 V, 3.2 V, 20 mA
290 Ω exact, 300 Ω E24 per LED
使用限制與精準度說明
- • Forward voltage varies with colour, current and temperature, so use the datasheet value and verify with a meter.
- • Sharing one resistor between parallel LEDs is not recommended; small differences in forward voltage make the currents unequal.
瀏覽器本地運算與隱私保障
傳統線上轉換網站會將您的文件、文字片段或影音檔案上傳至遠端伺服器。LED 串聯與並聯電阻計算器 完全在您的瀏覽器分頁內運行:
您的檔案與文字都在裝置本機計算,不會傳送內容至任何後端伺服器。
Microdeck 不會記錄或儲存您在工具內貼上的任何檔案或程式碼。
所有暫存結果僅存在目前分頁記憶體中,重設或關閉分頁後即刻清除。
常見問題 (FAQ)
Why not use a resistor slightly below the calculated value?
A smaller resistor passes more current. Rounding up to the next E24 value keeps the LED at or below the target current.
What if my supply is lower than the total forward voltage?
The LEDs will not reach full brightness. Use fewer LEDs in series or a higher supply, or split them into parallel branches.
Is anything uploaded?
No. The calculation happens in your browser.