작동 원리 및 구조
The resistor drops whatever voltage the LEDs do not use: R = (supply − number of LEDs in series × forward voltage) ÷ current. For a parallel bank with one resistor per LED each branch is calculated separately. With one shared resistor the currents add, so the resistor carries the total and the LEDs share it unevenly, which is why the tool flags that layout.
단계별 사용 방법
Choose the layout: one LED or a series string, parallel with one resistor per LED, or parallel sharing one resistor.
Enter the supply voltage, the LED forward voltage from its datasheet and the target current.
Enter how many LEDs you are driving.
Read the exact resistance, the next standard E24 value, the resistor power and the real current with that standard part.
주요 기능 및 장점
- Three layouts in one tool
- Rounds up to the next E24 value so the LED never exceeds the target current
- Resistor power with a safe rating suggestion
- Warns when the supply is too low for the LEDs in series
계산 방식, 공식 및 기술 표준
Ohm law on the leftover voltage. The standard value is the smallest E24 value at or above the exact result, so real current is slightly lower than the target.
입출력 예시 및 엣지 케이스
Three LEDs in series
12 V supply, 3.2 V forward, 20 mA, 3 LEDs in series
120 Ω, 0.048 W
12 − 3 × 3.2 = 2.4 V across the resistor; 2.4 ÷ 0.02 = 120 Ω.
Four parallel LEDs, one resistor each
9 V, 3.2 V, 20 mA
290 Ω exact, 300 Ω E24 per LED
제한 사항 및 정확도 안내
- • Forward voltage varies with colour, current and temperature, so use the datasheet value and verify with a meter.
- • Sharing one resistor between parallel LEDs is not recommended; small differences in forward voltage make the currents unequal.
브라우저 로컬 처리 및 개인정보 보호
일반 웹 변환기는 문서나 미디어 파일을 원격 서버에 업로드합니다. LED 직렬·병렬 저항 계산기 도구는 현재 브라우저 탭 내부에서만 실행됩니다:
입력 텍스트와 파일은 외부 서버로 전송되지 않고 기기 내에서 로컬로 계산됩니다.
도구에 붙여넣은 파일이나 데이터를 서버에 기록하거나 저장하지 않습니다.
작업 결과는 브라우저 탭 메모리에만 유지되며 탭을 닫거나 초기화하면 즉시 해제됩니다.
자주 묻는 질문 (FAQ)
Why not use a resistor slightly below the calculated value?
A smaller resistor passes more current. Rounding up to the next E24 value keeps the LED at or below the target current.
What if my supply is lower than the total forward voltage?
The LEDs will not reach full brightness. Use fewer LEDs in series or a higher supply, or split them into parallel branches.
Is anything uploaded?
No. The calculation happens in your browser.