Cara Kerja di Balik Layar
The resistor drops whatever voltage the LEDs do not use: R = (supply − number of LEDs in series × forward voltage) ÷ current. For a parallel bank with one resistor per LED each branch is calculated separately. With one shared resistor the currents add, so the resistor carries the total and the LEDs share it unevenly, which is why the tool flags that layout.
Panduan Langkah demi Langkah
Choose the layout: one LED or a series string, parallel with one resistor per LED, or parallel sharing one resistor.
Enter the supply voltage, the LED forward voltage from its datasheet and the target current.
Enter how many LEDs you are driving.
Read the exact resistance, the next standard E24 value, the resistor power and the real current with that standard part.
Fitur Utama & Performa
- Three layouts in one tool
- Rounds up to the next E24 value so the LED never exceeds the target current
- Resistor power with a safe rating suggestion
- Warns when the supply is too low for the LEDs in series
Metodologi, Rumus & Standar Teknis
Ohm law on the leftover voltage. The standard value is the smallest E24 value at or above the exact result, so real current is slightly lower than the target.
Contoh Kasus & Uji Coba
Three LEDs in series
12 V supply, 3.2 V forward, 20 mA, 3 LEDs in series
120 Ω, 0.048 W
12 − 3 × 3.2 = 2.4 V across the resistor; 2.4 ÷ 0.02 = 120 Ω.
Four parallel LEDs, one resistor each
9 V, 3.2 V, 20 mA
290 Ω exact, 300 Ω E24 per LED
Catatan Batasan & Akurasi
- • Forward voltage varies with colour, current and temperature, so use the datasheet value and verify with a meter.
- • Sharing one resistor between parallel LEDs is not recommended; small differences in forward voltage make the currents unequal.
Pemrosesan Lokal di Browser & Privasi
Konverter web konvensional mengunggah dokumen, teks, atau media ke server jarak jauh. Kalkulator Resistor LED Seri & Paralel berjalan langsung di tab browser Anda:
Teks dan file Anda diproses secara lokal tanpa mengirim muatan apa pun ke server.
Microdeck tidak mencatat atau menyimpan file dan teks yang Anda masukkan ke ruang kerja alat.
Hasil kerja hanya tersimpan di memori tab dan langsung terhapus saat Anda me-reset atau menutup tab.
Pertanyaan yang Sering Diajukan (FAQ)
Why not use a resistor slightly below the calculated value?
A smaller resistor passes more current. Rounding up to the next E24 value keeps the LED at or below the target current.
What if my supply is lower than the total forward voltage?
The LEDs will not reach full brightness. Use fewer LEDs in series or a higher supply, or split them into parallel branches.
Is anything uploaded?
No. The calculation happens in your browser.
Jelajahi Alat Mikro Terkait
Kalkulator Hukum Ohm & Daya
Masukkan dua dari tegangan, arus, hambatan, atau daya untuk mendapat dua lainnya
Kalkulator Kode Warna Resistor
Resistor 4, 5, dan 6 gelang: warna ke nilai, nilai ke warna, E24 terdekat
Kalkulator Pembagi Tegangan
Tegangan keluaran dari dua resistor, atau R2 untuk tegangan target, dengan efek beban