仕組みと内部処理
The resistor drops whatever voltage the LEDs do not use: R = (supply − number of LEDs in series × forward voltage) ÷ current. For a parallel bank with one resistor per LED each branch is calculated separately. With one shared resistor the currents add, so the resistor carries the total and the LEDs share it unevenly, which is why the tool flags that layout.
使い方ステップ
Choose the layout: one LED or a series string, parallel with one resistor per LED, or parallel sharing one resistor.
Enter the supply voltage, the LED forward voltage from its datasheet and the target current.
Enter how many LEDs you are driving.
Read the exact resistance, the next standard E24 value, the resistor power and the real current with that standard part.
主な機能と特長
- Three layouts in one tool
- Rounds up to the next E24 value so the LED never exceeds the target current
- Resistor power with a safe rating suggestion
- Warns when the supply is too low for the LEDs in series
計算ロジック・仕様・技術基準
Ohm law on the leftover voltage. The standard value is the smallest E24 value at or above the exact result, so real current is slightly lower than the target.
入出力の例・エッジケース
Three LEDs in series
12 V supply, 3.2 V forward, 20 mA, 3 LEDs in series
120 Ω, 0.048 W
12 − 3 × 3.2 = 2.4 V across the resistor; 2.4 ÷ 0.02 = 120 Ω.
Four parallel LEDs, one resistor each
9 V, 3.2 V, 20 mA
290 Ω exact, 300 Ω E24 per LED
仕様上の制限・精度に関するご注意
- • Forward voltage varies with colour, current and temperature, so use the datasheet value and verify with a meter.
- • Sharing one resistor between parallel LEDs is not recommended; small differences in forward voltage make the currents unequal.
ブラウザ内ローカル処理とプライバシー保護
一般的なWebツールは文書やメディアを外部サーバーへ送信します。LED抵抗計算機(直列・並列) はお使いのブラウザタブ内のみで完結します:
入力テキストやファイルは端末内で処理され、外部の処理サーバーへアップロードされません。
作業内容や貼り付けたデータを保存・記録しません(通常の静的配信CDNリクエストのみ発生します)。
作業データはタブ内のメモリ上のみに保持され、リセットまたはタブを閉じると破棄されます。
よくある質問 (FAQ)
Why not use a resistor slightly below the calculated value?
A smaller resistor passes more current. Rounding up to the next E24 value keeps the LED at or below the target current.
What if my supply is lower than the total forward voltage?
The LEDs will not reach full brightness. Use fewer LEDs in series or a higher supply, or split them into parallel branches.
Is anything uploaded?
No. The calculation happens in your browser.