Como funciona por dentro
IPC-2221 gives the allowed current as I = k × ΔT^0.44 × A^0.725, where A is the copper cross-section in square mils, ΔT is the temperature rise in °C and k is 0.048 for outer layers and 0.024 for inner layers. The tool inverts it to get the area for a current, then divides by copper thickness (1 oz is about 1.378 mil, or 35 µm) to get the width.
Passo a passo de uso
Enter the current and the temperature rise you can accept.
Choose copper weight and whether the trace is on an external or internal layer.
Optionally enter the trace length to get resistance and voltage drop.
Read the width in mm and mil.
Principais recursos e vantagens
- Width from current, or current from width
- External and internal layers
- Resistance and voltage drop for a trace length
- Millimetre and mil results
Metodologia, fórmulas e padrões técnicos
IPC-2221 curves were fitted for currents up to about 35 A, widths up to 400 mil and rises of 10 to 100 °C. Resistance uses copper at 20 °C.
Exemplos resolvidos e casos especiais
3 A on an outer layer
3 A, 10 °C rise, 1 oz copper, external
about 1.37 mm wide
An inner layer needs more than twice the width.
Limitações e notas de precisão
- • IPC-2221 is conservative for external layers and less accurate for very high currents; IPC-2152 gives better data when you need it.
- • It ignores nearby heat sources, copper pours that help cooling and vias, so check hot designs by test.
Processamento local no navegador e privacidade
Conversores comuns enviam seus documentos, códigos ou vídeos para servidores externos. O Largura de trilha PCB e capacidade de corrente roda direto na sua aba:
Seus textos e arquivos são processados localmente sem enviar conteúdo para servidores.
O Microdeck não registra nem armazena arquivos ou dados colados nas ferramentas.
Os resultados ficam apenas na memória do navegador e somem ao fechar ou limpar a aba.
Perguntas frequentes (FAQ)
Why are internal traces wider?
Inner copper is surrounded by laminate and cannot shed heat to air, so the same current causes a bigger temperature rise.
What temperature rise should I pick?
10 °C is a common safe choice. Higher rises save space but heat the board and nearby parts.
Does this replace a design rule check?
No. It is a quick estimate; confirm with your fab and safety standards, especially for mains voltages.
Outras ferramentas relacionadas
Bitola de fio (AWG) e queda de tensão
Escolha o fio pela corrente e comprimento, ou verifique a queda de tensão
Calculadora da lei de Ohm e potência
Informe duas entre tensão, corrente, resistência e potência e obtenha as outras duas
Calculadora de código de cores de resistores
Resistores de 4, 5 e 6 faixas: cores para valor, valor para cores, E24 mais próximo