Microdeck.tools 100 % en el navegador

Ancho de pista PCB y capacidad de corriente

New

Calcule el ancho de pista necesario según corriente, grosor de cobre y aumento de temperatura, o la corriente máxima de una pista existente.

100 % en tu navegador Sin subir archivos Resultados al instante

¿Te ahorró tiempo esta herramienta? Ayuda a mantener Microdeck gratis y al día. Opcional · Desde $3.

Cómo funciona por dentro

IPC-2221 gives the allowed current as I = k × ΔT^0.44 × A^0.725, where A is the copper cross-section in square mils, ΔT is the temperature rise in °C and k is 0.048 for outer layers and 0.024 for inner layers. The tool inverts it to get the area for a current, then divides by copper thickness (1 oz is about 1.378 mil, or 35 µm) to get the width.

Instrucciones paso a paso

1

Enter the current and the temperature rise you can accept.

2

Choose copper weight and whether the trace is on an external or internal layer.

3

Optionally enter the trace length to get resistance and voltage drop.

4

Read the width in mm and mil.

Funciones principales y ventajas

  • Width from current, or current from width
  • External and internal layers
  • Resistance and voltage drop for a trace length
  • Millimetre and mil results

Metodología, fórmulas y estándares técnicos

IPC-2221 curves were fitted for currents up to about 35 A, widths up to 400 mil and rises of 10 to 100 °C. Resistance uses copper at 20 °C.

Ejemplos prácticos y casos límite

3 A on an outer layer

Entrada
3 A, 10 °C rise, 1 oz copper, external
Salida
about 1.37 mm wide

An inner layer needs more than twice the width.

Límites y notas de precisión

  • • IPC-2221 is conservative for external layers and less accurate for very high currents; IPC-2152 gives better data when you need it.
  • • It ignores nearby heat sources, copper pours that help cooling and vias, so check hot designs by test.

Procesamiento local en tu navegador y privacidad

Los conversores tradicionales suben tus documentos, textos o archivos multimedia a servidores remotos. Ancho de pista PCB y capacidad de corriente se ejecuta dentro de tu pestaña:

Procesado en esta pestaña

Tus textos y archivos se procesan localmente sin enviarse a ningún servidor externo.

Sin registro de tus archivos

Microdeck no guarda ni registra el contenido que introduces en las herramientas.

Memoria temporal de la pestaña

Los resultados permanecen en la memoria de tu navegador y se liberan al cerrar o reiniciar.

Preguntas frecuentes (FAQ)

Why are internal traces wider?

Inner copper is surrounded by laminate and cannot shed heat to air, so the same current causes a bigger temperature rise.

What temperature rise should I pick?

10 °C is a common safe choice. Higher rises save space but heat the board and nearby parts.

Does this replace a design rule check?

No. It is a quick estimate; confirm with your fab and safety standards, especially for mains voltages.

Explora herramientas relacionadas

Apoyar a Microdeck

Totalmente opcional · Desde $3 · Sin cuenta

Elige un importe (USD):Seleccionado:$5

El aporte mínimo es de $3 USD.

Totalmente opcional · Desde $3 · Pago seguro en Gumroad.