So funktioniert es unter der Haube
IPC-2221 gives the allowed current as I = k × ΔT^0.44 × A^0.725, where A is the copper cross-section in square mils, ΔT is the temperature rise in °C and k is 0.048 for outer layers and 0.024 for inner layers. The tool inverts it to get the area for a current, then divides by copper thickness (1 oz is about 1.378 mil, or 35 µm) to get the width.
Schritt-für-Schritt-Anleitung
Enter the current and the temperature rise you can accept.
Choose copper weight and whether the trace is on an external or internal layer.
Optionally enter the trace length to get resistance and voltage drop.
Read the width in mm and mil.
Wichtige Funktionen & Vorteile
- Width from current, or current from width
- External and internal layers
- Resistance and voltage drop for a trace length
- Millimetre and mil results
Methodik, Formeln & technische Standards
IPC-2221 curves were fitted for currents up to about 35 A, widths up to 400 mil and rises of 10 to 100 °C. Resistance uses copper at 20 °C.
Praxisbeispiele & Grenzfälle
3 A on an outer layer
3 A, 10 °C rise, 1 oz copper, external
about 1.37 mm wide
An inner layer needs more than twice the width.
Hinweise zu Grenzen & Genauigkeit
- • IPC-2221 is conservative for external layers and less accurate for very high currents; IPC-2152 gives better data when you need it.
- • It ignores nearby heat sources, copper pours that help cooling and vias, so check hot designs by test.
Lokale Verarbeitung im Browser & Datenschutz
Herkömmliche Online-Konverter laden Ihre Dokumente, Texte oder Mediendateien auf fremde Server. Leiterbahnbreite & Strombelastbarkeit (PCB) läuft direkt in Ihrem Browser-Tab:
Ihre Texte und Dateien werden lokal berechnet, ohne Inhalte an einen Verarbeitungsserver zu senden.
Microdeck protokolliert oder speichert weder Ihre Dateien noch Texteingaben (normale CDN-Abrufe laden lediglich die statische Seite).
Arbeitsergebnisse bleiben ausschließlich im Arbeitsspeicher des Tabs und werden beim Zurücksetzen oder Schließen freigegeben.
Häufig gestellte Fragen (FAQ)
Why are internal traces wider?
Inner copper is surrounded by laminate and cannot shed heat to air, so the same current causes a bigger temperature rise.
What temperature rise should I pick?
10 °C is a common safe choice. Higher rises save space but heat the board and nearby parts.
Does this replace a design rule check?
No. It is a quick estimate; confirm with your fab and safety standards, especially for mains voltages.
Ähnliche Mikro-Tools entdecken
Leitungsquerschnitt (AWG) & Spannungsabfall
Drahtgröße für Strom und Länge wählen oder den Spannungsabfall prüfen
Ohmsches Gesetz & Leistung berechnen
Zwei von Spannung, Strom, Widerstand und Leistung eingeben, die anderen zwei erhalten
Widerstand-Farbcode-Rechner
Widerstände mit 4, 5 und 6 Ringen: Farben zu Wert, Wert zu Farben, nächster E24-Wert