작동 원리 및 구조
In astable mode the capacitor charges through R1 and R2 and discharges through R2, so the output high time is 0.693 × (R1 + R2) × C and the low time is 0.693 × R2 × C. In monostable mode one trigger gives one pulse of 1.1 × R × C. The tool does both and shows the period, frequency and duty cycle.
단계별 사용 방법
Choose astable or monostable.
Enter the resistors and the capacitor, for example 1k, 10k and 10n.
Read the frequency, period, high and low times, or the pulse width.
주요 기능 및 장점
- Astable and monostable
- Frequency, period, high time, low time and duty cycle
- SI suffix input
- Warns about a too-small R1
계산 방식, 공식 및 기술 표준
Astable: f = 1 / (ln2 × (R1 + 2R2) × C). Monostable: T = ln3 × R × C ≈ 1.1 × R × C.
입출력 예시 및 엣지 케이스
R1 1k, R2 10k, C 10n
Astable
≈ 6.9 kHz, duty ≈ 52%
R 100k, C 10n
Monostable
≈ 1.1 ms
제한 사항 및 정확도 안내
- • Tolerance of the 555 and the components shifts the result by several percent.
- • The standard astable circuit cannot give a duty cycle below 50%.
브라우저 로컬 처리 및 개인정보 보호
일반 웹 변환기는 문서나 미디어 파일을 원격 서버에 업로드합니다. 555 타이머 IC 계산기 (비안정 / 단안정 모드) 도구는 현재 브라우저 탭 내부에서만 실행됩니다:
입력 텍스트와 파일은 외부 서버로 전송되지 않고 기기 내에서 로컬로 계산됩니다.
도구에 붙여넣은 파일이나 데이터를 서버에 기록하거나 저장하지 않습니다.
작업 결과는 브라우저 탭 메모리에만 유지되며 탭을 닫거나 초기화하면 즉시 해제됩니다.
자주 묻는 질문 (FAQ)
How do I get a 50% duty cycle?
Add a diode in parallel with R2, or divide the output by two with a flip-flop.
Does it work for NE555, LM555 and the CMOS 7555?
Yes, the timing equations are the same.
Is anything stored?
No.