仕組みと内部処理
In astable mode the capacitor charges through R1 and R2 and discharges through R2, so the output high time is 0.693 × (R1 + R2) × C and the low time is 0.693 × R2 × C. In monostable mode one trigger gives one pulse of 1.1 × R × C. The tool does both and shows the period, frequency and duty cycle.
使い方ステップ
Choose astable or monostable.
Enter the resistors and the capacitor, for example 1k, 10k and 10n.
Read the frequency, period, high and low times, or the pulse width.
主な機能と特長
- Astable and monostable
- Frequency, period, high time, low time and duty cycle
- SI suffix input
- Warns about a too-small R1
計算ロジック・仕様・技術基準
Astable: f = 1 / (ln2 × (R1 + 2R2) × C). Monostable: T = ln3 × R × C ≈ 1.1 × R × C.
入出力の例・エッジケース
R1 1k, R2 10k, C 10n
Astable
≈ 6.9 kHz, duty ≈ 52%
R 100k, C 10n
Monostable
≈ 1.1 ms
仕様上の制限・精度に関するご注意
- • Tolerance of the 555 and the components shifts the result by several percent.
- • The standard astable circuit cannot give a duty cycle below 50%.
ブラウザ内ローカル処理とプライバシー保護
一般的なWebツールは文書やメディアを外部サーバーへ送信します。555タイマーIC計算機 (無安定・単安定モード) はお使いのブラウザタブ内のみで完結します:
入力テキストやファイルは端末内で処理され、外部の処理サーバーへアップロードされません。
作業内容や貼り付けたデータを保存・記録しません(通常の静的配信CDNリクエストのみ発生します)。
作業データはタブ内のメモリ上のみに保持され、リセットまたはタブを閉じると破棄されます。
よくある質問 (FAQ)
How do I get a 50% duty cycle?
Add a diode in parallel with R2, or divide the output by two with a flip-flop.
Does it work for NE555, LM555 and the CMOS 7555?
Yes, the timing equations are the same.
Is anything stored?
No.