底層運作原理
Print a single-wall cube, measure the wall with calipers and compare it to the line width in your slicer. The new multiplier is the old one times expected over measured. If your filament is not the stated diameter, the tool also gives the flow factor (nominal ÷ measured)².
詳細操作步驟
Enter the current flow value.
Enter the expected and measured wall thickness.
Optionally enter the nominal and measured filament diameter.
Apply the new value and print another cube.
核心功能與效能優勢
- Wall test method
- Filament diameter method
- Warning for large changes
運算方法、公式與技術標準
New = current × expected ÷ measured. Diameter factor = (nominal ÷ measured)².
實作範例與邊界案例
0.45 expected, 0.48 measured
Current 100%
New 93.75%
使用限制與精準度說明
- • Calibrate E-steps and temperature first.
瀏覽器本地運算與隱私保障
傳統線上轉換網站會將您的文件、文字片段或影音檔案上傳至遠端伺服器。擠出乘數與出料流量補正計算器 (Flow Rate) 完全在您的瀏覽器分頁內運行:
您的檔案與文字都在裝置本機計算,不會傳送內容至任何後端伺服器。
Microdeck 不會記錄或儲存您在工具內貼上的任何檔案或程式碼。
所有暫存結果僅存在目前分頁記憶體中,重設或關閉分頁後即刻清除。
常見問題 (FAQ)
Is flow the same as extrusion multiplier?
Yes, slicers use both names for the same setting.
How many measurements?
Average at least four points around the cube.
Is data uploaded?
No.