仕組みと内部処理
Print a single-wall cube, measure the wall with calipers and compare it to the line width in your slicer. The new multiplier is the old one times expected over measured. If your filament is not the stated diameter, the tool also gives the flow factor (nominal ÷ measured)².
使い方ステップ
Enter the current flow value.
Enter the expected and measured wall thickness.
Optionally enter the nominal and measured filament diameter.
Apply the new value and print another cube.
主な機能と特長
- Wall test method
- Filament diameter method
- Warning for large changes
計算ロジック・仕様・技術基準
New = current × expected ÷ measured. Diameter factor = (nominal ÷ measured)².
入出力の例・エッジケース
0.45 expected, 0.48 measured
Current 100%
New 93.75%
仕様上の制限・精度に関するご注意
- • Calibrate E-steps and temperature first.
ブラウザ内ローカル処理とプライバシー保護
一般的なWebツールは文書やメディアを外部サーバーへ送信します。押し出し倍率・吐出量(Flow Rate)補正計算機 はお使いのブラウザタブ内のみで完結します:
入力テキストやファイルは端末内で処理され、外部の処理サーバーへアップロードされません。
作業内容や貼り付けたデータを保存・記録しません(通常の静的配信CDNリクエストのみ発生します)。
作業データはタブ内のメモリ上のみに保持され、リセットまたはタブを閉じると破棄されます。
よくある質問 (FAQ)
Is flow the same as extrusion multiplier?
Yes, slicers use both names for the same setting.
How many measurements?
Average at least four points around the cube.
Is data uploaded?
No.