Microdeck.tools 100% 브라우저 실행

압출 배율(Extrusion Multiplier) / 유량(Flow) 보정 계산기

New

슬라이서 목표 외벽 두께와 버니어 캘리퍼스로 실측한 두께를 비교하여 완벽한 압출 배율(Flow Rate %)을 산출합니다.

100% 브라우저 실행 서버 업로드 없음 즉시 결과 확인

이 도구가 시간을 절약하는 데 도움이 되었나요? Microdeck을 무료로 유지하고 개선하는 데 힘을 보태주세요. 자율 참여 · $3부터.

작동 원리 및 구조

Print a single-wall cube, measure the wall with calipers and compare it to the line width in your slicer. The new multiplier is the old one times expected over measured. If your filament is not the stated diameter, the tool also gives the flow factor (nominal ÷ measured)².

단계별 사용 방법

1

Enter the current flow value.

2

Enter the expected and measured wall thickness.

3

Optionally enter the nominal and measured filament diameter.

4

Apply the new value and print another cube.

주요 기능 및 장점

  • Wall test method
  • Filament diameter method
  • Warning for large changes

계산 방식, 공식 및 기술 표준

New = current × expected ÷ measured. Diameter factor = (nominal ÷ measured)².

입출력 예시 및 엣지 케이스

0.45 expected, 0.48 measured

입력
Current 100%
출력
New 93.75%

제한 사항 및 정확도 안내

  • • Calibrate E-steps and temperature first.

브라우저 로컬 처리 및 개인정보 보호

일반 웹 변환기는 문서나 미디어 파일을 원격 서버에 업로드합니다. 압출 배율(Extrusion Multiplier) / 유량(Flow) 보정 계산기 도구는 현재 브라우저 탭 내부에서만 실행됩니다:

현재 탭에서 직접 처리

입력 텍스트와 파일은 외부 서버로 전송되지 않고 기기 내에서 로컬로 계산됩니다.

입력 데이터 로그 미보관

도구에 붙여넣은 파일이나 데이터를 서버에 기록하거나 저장하지 않습니다.

일시적 탭 메모리 수명주기

작업 결과는 브라우저 탭 메모리에만 유지되며 탭을 닫거나 초기화하면 즉시 해제됩니다.

자주 묻는 질문 (FAQ)

Is flow the same as extrusion multiplier?

Yes, slicers use both names for the same setting.

How many measurements?

Average at least four points around the cube.

Is data uploaded?

No.

관련 마이크로 도구 살펴보기

Microdeck 후원하기

100% 자율 후원 · $3부터 · 회원가입 불필요

금액 선택 (USD):선택 금액:$5

최소 후원 금액은 $3 USD입니다.

100% 자율 · $3부터 · Gumroad 안전 결제 창이 열립니다.