작동 원리 및 구조
An unloaded divider gives Vout = Vin × R2 ÷ (R1 + R2). A load in parallel with R2 lowers the bottom resistance to R2 ∥ Rload, so the real output is lower. To hit a target, the tool solves R2 = R1 × Vout ÷ (Vin − Vout) and shows the nearest E24 part.
단계별 사용 방법
Choose whether to find the output voltage or the R2 for a target.
Enter Vin and R1 (4.7k, 10k and similar are accepted).
Enter R2 or the target voltage, and optionally a load resistance.
Read Vout, ratio, current, power and the loaded result.
주요 기능 및 장점
- Both directions in one tool
- Load resistance shows the voltage drop caused by the load
- Nearest E24 value for the target mode
- Power in each resistor
입출력 예시 및 엣지 케이스
12 V divider
Vin 12 V, R1 10 kΩ, R2 4.7 kΩ
3.837 V unloaded
12 × 4.7 ÷ 14.7.
Hit 3.3 V
Vin 12 V, R1 10 kΩ, target 3.3 V
R2 = 3.79 kΩ, nearest E24 3.9 kΩ
제한 사항 및 정확도 안내
- • A divider is a poor power supply: any real load pulls the output down. Use a regulator for loads above a few milliamps.
- • Resistor tolerance (1% to 5%) shifts the output by a similar amount.
브라우저 로컬 처리 및 개인정보 보호
일반 웹 변환기는 문서나 미디어 파일을 원격 서버에 업로드합니다. 전압 분배기 계산기 도구는 현재 브라우저 탭 내부에서만 실행됩니다:
입력 텍스트와 파일은 외부 서버로 전송되지 않고 기기 내에서 로컬로 계산됩니다.
도구에 붙여넣은 파일이나 데이터를 서버에 기록하거나 저장하지 않습니다.
작업 결과는 브라우저 탭 메모리에만 유지되며 탭을 닫거나 초기화하면 즉시 해제됩니다.
자주 묻는 질문 (FAQ)
Can I power a microcontroller from a divider?
Only for a signal input with almost no current. For power, use a regulator, because the divider voltage changes with load.
How do I reduce loading error?
Make R1 and R2 at least 10 times smaller than the load resistance, at the cost of more standing current.
Is the data private?
Yes, everything runs locally.