Cómo funciona por dentro
An unloaded divider gives Vout = Vin × R2 ÷ (R1 + R2). A load in parallel with R2 lowers the bottom resistance to R2 ∥ Rload, so the real output is lower. To hit a target, the tool solves R2 = R1 × Vout ÷ (Vin − Vout) and shows the nearest E24 part.
Instrucciones paso a paso
Choose whether to find the output voltage or the R2 for a target.
Enter Vin and R1 (4.7k, 10k and similar are accepted).
Enter R2 or the target voltage, and optionally a load resistance.
Read Vout, ratio, current, power and the loaded result.
Funciones principales y ventajas
- Both directions in one tool
- Load resistance shows the voltage drop caused by the load
- Nearest E24 value for the target mode
- Power in each resistor
Ejemplos prácticos y casos límite
12 V divider
Vin 12 V, R1 10 kΩ, R2 4.7 kΩ
3.837 V unloaded
12 × 4.7 ÷ 14.7.
Hit 3.3 V
Vin 12 V, R1 10 kΩ, target 3.3 V
R2 = 3.79 kΩ, nearest E24 3.9 kΩ
Límites y notas de precisión
- • A divider is a poor power supply: any real load pulls the output down. Use a regulator for loads above a few milliamps.
- • Resistor tolerance (1% to 5%) shifts the output by a similar amount.
Procesamiento local en tu navegador y privacidad
Los conversores tradicionales suben tus documentos, textos o archivos multimedia a servidores remotos. Calculadora de divisor de tensión se ejecuta dentro de tu pestaña:
Tus textos y archivos se procesan localmente sin enviarse a ningún servidor externo.
Microdeck no guarda ni registra el contenido que introduces en las herramientas.
Los resultados permanecen en la memoria de tu navegador y se liberan al cerrar o reiniciar.
Preguntas frecuentes (FAQ)
Can I power a microcontroller from a divider?
Only for a signal input with almost no current. For power, use a regulator, because the divider voltage changes with load.
How do I reduce loading error?
Make R1 and R2 at least 10 times smaller than the load resistance, at the cost of more standing current.
Is the data private?
Yes, everything runs locally.
Explora herramientas relacionadas
Calculadora de ley de Ohm y potencia
Introduzca dos de tensión, corriente, resistencia o potencia y obtenga las otras dos
Calculadora de código de colores de resistencias
Resistencias de 4, 5 y 6 bandas: colores a valor, valor a colores, E24 más cercano
Calculadora de resistencia para LED en serie y paralelo
Resistencia limitadora para un LED, una cadena en serie o un banco en paralelo