작동 원리 및 구조
Force is pressure times piston area, reduced by an efficiency factor for friction. The pull force is lower because the rod takes up part of the area. Air use is the swept volume of both strokes multiplied by the compression ratio, which converts it to free air for sizing a compressor.
단계별 사용 방법
Enter bore, rod, stroke and working pressure.
Set the efficiency and cycles per minute.
Read push and pull force and the air consumption.
주요 기능 및 장점
- bar, psi, MPa and kPa
- Push and pull force in N and kgf
- Free air per cycle and per minute
- Compressor delivery with 30% margin
계산 방식, 공식 및 기술 표준
F = P × A × η. Free air = swept volume × (P + 1.013) ÷ 1.013.
입출력 예시 및 엣지 케이스
50 mm bore at 6 bar
Rod 20 mm
Push ≈ 1060 N
제한 사항 및 정확도 안내
- • Ignores dead volume in tubes and valves.
- • Add a safety factor of 1.5–2 for the load.
브라우저 로컬 처리 및 개인정보 보호
일반 웹 변환기는 문서나 미디어 파일을 원격 서버에 업로드합니다. 공압 실린더 추력 및 공기 소비량 계산기 도구는 현재 브라우저 탭 내부에서만 실행됩니다:
입력 텍스트와 파일은 외부 서버로 전송되지 않고 기기 내에서 로컬로 계산됩니다.
도구에 붙여넣은 파일이나 데이터를 서버에 기록하거나 저장하지 않습니다.
작업 결과는 브라우저 탭 메모리에만 유지되며 탭을 닫거나 초기화하면 즉시 해제됩니다.
자주 묻는 질문 (FAQ)
Why is the pull force smaller?
The rod reduces the effective piston area on the retract side.
What is free air?
Air volume at atmospheric pressure, the unit compressors are rated in.
Is anything uploaded?
No.