작동 원리 및 구조
Mark the filament, extrude a known length and measure how much actually went in. The new E-steps value is the old value times the requested length divided by the real length. The tool also reports the error and the G-code to apply and save the value.
단계별 사용 방법
Mark the filament 120 mm above the extruder.
Extrude 100 mm at printing temperature.
Measure the new distance to the mark.
Enter the numbers and apply the new E-steps.
주요 기능 및 장점
- Error percentage
- M92 and M500 commands
- Warning for large errors
계산 방식, 공식 및 기술 표준
New E-steps = current × requested ÷ actual.
입출력 예시 및 엣지 케이스
97 mm instead of 100 mm
Current 93
New ≈ 95.9
제한 사항 및 정확도 안내
- • Mechanical problems such as slipping give meaningless results.
- • Do E-steps first and flow rate second.
브라우저 로컬 처리 및 개인정보 보호
일반 웹 변환기는 문서나 미디어 파일을 원격 서버에 업로드합니다. 3D 프린터 E-steps 캘리브레이션 계산기 도구는 현재 브라우저 탭 내부에서만 실행됩니다:
입력 텍스트와 파일은 외부 서버로 전송되지 않고 기기 내에서 로컬로 계산됩니다.
도구에 붙여넣은 파일이나 데이터를 서버에 기록하거나 저장하지 않습니다.
작업 결과는 브라우저 탭 메모리에만 유지되며 탭을 닫거나 초기화하면 즉시 해제됩니다.
자주 묻는 질문 (FAQ)
How accurate must the measurement be?
Within about 0.5 mm; repeat the test to confirm.
Do I need to save it?
Yes, send M500 after M92.
Is data uploaded?
No.