Microdeck.tools 100 % en el navegador

Calculadora de Calibración de E-Steps para Impresora 3D

New

Soluciona la subextrusión o sobreextrusión calculando los nuevos E-steps a partir de una prueba de extrusión de 100 mm.

100 % en tu navegador Sin subir archivos Resultados al instante

¿Te ahorró tiempo esta herramienta? Ayuda a mantener Microdeck gratis y al día. Opcional · Desde $3.

Cómo funciona por dentro

Mark the filament, extrude a known length and measure how much actually went in. The new E-steps value is the old value times the requested length divided by the real length. The tool also reports the error and the G-code to apply and save the value.

Instrucciones paso a paso

1

Mark the filament 120 mm above the extruder.

2

Extrude 100 mm at printing temperature.

3

Measure the new distance to the mark.

4

Enter the numbers and apply the new E-steps.

Funciones principales y ventajas

  • Error percentage
  • M92 and M500 commands
  • Warning for large errors

Metodología, fórmulas y estándares técnicos

New E-steps = current × requested ÷ actual.

Ejemplos prácticos y casos límite

97 mm instead of 100 mm

Entrada
Current 93
Salida
New ≈ 95.9

Límites y notas de precisión

  • • Mechanical problems such as slipping give meaningless results.
  • • Do E-steps first and flow rate second.

Procesamiento local en tu navegador y privacidad

Los conversores tradicionales suben tus documentos, textos o archivos multimedia a servidores remotos. Calculadora de Calibración de E-Steps para Impresora 3D se ejecuta dentro de tu pestaña:

Procesado en esta pestaña

Tus textos y archivos se procesan localmente sin enviarse a ningún servidor externo.

Sin registro de tus archivos

Microdeck no guarda ni registra el contenido que introduces en las herramientas.

Memoria temporal de la pestaña

Los resultados permanecen en la memoria de tu navegador y se liberan al cerrar o reiniciar.

Preguntas frecuentes (FAQ)

How accurate must the measurement be?

Within about 0.5 mm; repeat the test to confirm.

Do I need to save it?

Yes, send M500 after M92.

Is data uploaded?

No.

Explora herramientas relacionadas

Apoyar a Microdeck

Totalmente opcional · Desde $3 · Sin cuenta

Elige un importe (USD):Seleccionado:$5

El aporte mínimo es de $3 USD.

Totalmente opcional · Desde $3 · Pago seguro en Gumroad.