仕組みと内部処理
Mark the filament, extrude a known length and measure how much actually went in. The new E-steps value is the old value times the requested length divided by the real length. The tool also reports the error and the G-code to apply and save the value.
使い方ステップ
Mark the filament 120 mm above the extruder.
Extrude 100 mm at printing temperature.
Measure the new distance to the mark.
Enter the numbers and apply the new E-steps.
主な機能と特長
- Error percentage
- M92 and M500 commands
- Warning for large errors
計算ロジック・仕様・技術基準
New E-steps = current × requested ÷ actual.
入出力の例・エッジケース
97 mm instead of 100 mm
Current 93
New ≈ 95.9
仕様上の制限・精度に関するご注意
- • Mechanical problems such as slipping give meaningless results.
- • Do E-steps first and flow rate second.
ブラウザ内ローカル処理とプライバシー保護
一般的なWebツールは文書やメディアを外部サーバーへ送信します。3Dプリンター E-steps校正計算機 はお使いのブラウザタブ内のみで完結します:
入力テキストやファイルは端末内で処理され、外部の処理サーバーへアップロードされません。
作業内容や貼り付けたデータを保存・記録しません(通常の静的配信CDNリクエストのみ発生します)。
作業データはタブ内のメモリ上のみに保持され、リセットまたはタブを閉じると破棄されます。
よくある質問 (FAQ)
How accurate must the measurement be?
Within about 0.5 mm; repeat the test to confirm.
Do I need to save it?
Yes, send M500 after M92.
Is data uploaded?
No.