Fonctionnement technique
Panel watts = daily energy ÷ (peak sun hours × system efficiency). Battery energy = daily energy × days of autonomy ÷ depth of discharge, converted to amp-hours by the system voltage. The controller must handle the panel array current, so the tool divides panel watts by battery voltage and adds a 25% safety margin before choosing a standard rating.
Mode d’emploi étape par étape
Enter your daily energy use in watt-hours.
Enter peak sun hours for your location and the overall system efficiency.
Set days of autonomy, depth of discharge and system voltage (12, 24 or 48 V).
Optionally enter the watts of the panel you plan to buy to get a panel count.
Fonctionnalités & performances
- Panel, battery and controller in one pass
- Standard controller ratings such as 10, 20, 30, 40, 60 A
- Panel count for your chosen panel size
- Lead-acid or lithium depth of discharge
Exemples concrets & cas limites
Small cabin
1,200 Wh/day, 4.5 sun hours, 75% efficiency, 2 days, 50% DoD, 12 V
356 W of panels, 4,800 Wh (400 Ah) battery, 40 A controller
Limites & notes de précision
- • Peak sun hours vary by month; size for the worst month if you need year-round power.
- • This is a planning estimate. Wire sizing, fusing, panel voltage limits of the controller and local code need a separate check.
Traitement local dans le navigateur & confidentialité
Les convertisseurs classiques envoient vos documents, extraits ou médias sur des serveurs distants. Dimensionnement panneau solaire et régulateur de charge s’exécute directement dans votre onglet :
Vos textes et fichiers sont traités localement sans aucun envoi vers un serveur de calcul.
Microdeck n’enregistre ni ne stocke les fichiers ou données collés dans les outils.
Les résultats restent dans la mémoire de votre onglet et sont libérés dès que vous le fermez.
Questions fréquentes (FAQ)
What are peak sun hours?
The equivalent hours per day of 1,000 W/m² sunlight. Most inhabited areas have 3 to 6.
What depth of discharge is safe?
About 50% for lead-acid and 80% or more for LiFePO4, following the battery maker datasheet.
MPPT or PWM?
MPPT harvests more from panels whose voltage is above the battery, at higher cost. For small 12 V systems with matched panels, PWM can be enough.
Outils associés à découvrir
Estimateur d’autonomie de batterie
Combien de temps tient une batterie ? Capacité, part utilisable, charge et cycle
Section de fil (AWG) et chute de tension
Choisir la section selon le courant et la longueur, ou vérifier la chute de tension
Calculateur loi d’Ohm et puissance
Entrez deux valeurs parmi tension, courant, résistance et puissance