Cómo funciona por dentro
Choose the algorithm (Modbus is the default), enter the frame bytes in hex such as 01 03 00 00 00 0A, and read the CRC. Modbus RTU sends the low byte first, and the tool shows the frame with the CRC appended.
Instrucciones paso a paso
Choose the algorithm.
Enter hex bytes or ASCII text.
Copy the CRC or the full frame.
Funciones principales y ventajas
- CRC-16/MODBUS, CCITT-FALSE, XMODEM, KERMIT, ARC
- Hex or text input
- Low-byte-first order
- Frame with CRC
Metodología, fórmulas y estándares técnicos
A bitwise CRC with the polynomial, start value and bit order of the chosen algorithm. For Modbus: polynomial 0x8005 reflected, start 0xFFFF.
Ejemplos prácticos y casos límite
01 03 00 00 00 0A
CRC 0xCDC5
Bytes C5 CD
Límites y notas de precisión
- • Check against your device before use in a real installation.
- • Input is limited to what the browser can handle; very long data is not the intended use.
Procesamiento local en tu navegador y privacidad
Los conversores tradicionales suben tus documentos, textos o archivos multimedia a servidores remotos. Calculadora de CRC-16 Modbus RTU Online se ejecuta dentro de tu pestaña:
Tus textos y archivos se procesan localmente sin enviarse a ningún servidor externo.
Microdeck no guarda ni registra el contenido que introduces en las herramientas.
Los resultados permanecen en la memoria de tu navegador y se liberan al cerrar o reiniciar.
Preguntas frecuentes (FAQ)
Which byte comes first in Modbus RTU?
The low byte of the CRC is sent first, then the high byte.
Is anything uploaded?
No. Everything runs in your browser and your data stays on your device.
Explora herramientas relacionadas
Verificar Checksum SHA-256 y Firmas HMAC
Calcula hashes SHA-1/256/384/512 de archivos y valida firmas HMAC en tu navegador.
Visualizador de Bits y Máscaras de Registros (Bitmask)
Visualiza cada bit de registros de 8, 16 o 32 bits y aplica operaciones AND, OR, XOR y desplazamientos
Guía de Pines de ESP32 y Arduino (Pinout Reference)
Consulta funciones GPIO, ADC, PWM, I2C, SPI, UART y pines a evitar en ESP32, Uno, Nano y NodeMCU